We have stack of 9300x switches that was very slow when connecting to CLI or WebUI.We thought a IOS update to 17.14.01 would solve this. After the upgrade we can't connect with SSH or console to the stack anymore. If we try via another acces switch t...
Forum Posts
Hi We have requirements to configure three VLANs for single SSID on C9120 EWC. When we try to configure, we couldn't options for vlan groups anything like that.
Hello, this is Cisco Community. Only certain PDA devices cannot connect wirelessly.As for the wireless communication specifications of the PDA device, the device supports all 802.11 a/b/g/n/ac.Additionally, both WPA 1 and 2 PSK are supported in the W...
our setup is running 9300 Essential switch on different place and all the vrrp is configured for both switches. When we connect the 9120 AXI EWC to the switch only WAP MAC is learning and not EWC virtual MAC. When we analyze the issue vrrp virtual ad...
How to backup running config for Cisco 5500 WLAN Controller using putty or Tera term.
Resolved! Lightweight AP disable console logging
Hello Guys,how can i disable logging, when i am connected to an LWAP via console ?I guess on a switch its something like "no logging console".Is there a Lightweight AP CLI command reference ?Thanks for help !Greetings
Hello,I wonder what effect changing the external antenna gain has on the access points? Can the change be made in production or do they need to reboot or similar?I don't have much experience in Cisco wireless, hope someone can help me.Thanks in advan...
Dear Experts,We got a small setup with 6 standalone AP model 1142 with external DHCP server. AP connects SW -> FW -> Dhcp relay on FW -> DHCP server. The issue is user get connected to that AP but with no IP assigned. we noticed that AP cannot provid...
We have AIR-AP1815T-A-K9 deployed in OEAP Teleworker Mode (WPA2 Enterprise AES) and the maximum throughput I can get is 200 Mbs download and 300 Mbs upload (tried wireless and wired LAN 1 port). There is no other throttling or bottle neck in the Netw...
I have a certificate installed and working on my WLC9800 for webauth. The same certificate does not seem to be working for Webadmin.For Webadmin I went into administration > management > HTTP/HTTPS/Netconf/VTY and changed the trustpoint to the one I...
Resolved! c9800 Flex Connect Post Auth ACL Issue
I already have a TAC case open on this but I wanted to see if anyone else has run across this...I am deploying new c9800-40's and have a requirement to do flex connect with CWA. I had this set up with my 5520's and it worked without issue but for som...
AP Join profile>management> user configuration fail when set aes encryption. it can success when set clear. AES is not working? is it a bug or configuration issue.
Dear allDuring few weeks I have tried to identify a mobility issue. I have a local environment with a good coverage and many type of devices, however, the honeywell handhelds corporate managed by SOTI platform, stuck during the roaming and the only w...
Hello,When we use Flex Connect, what happen with the AP when the controller goes down? Is the AP can serve the client? Will client will disassociate when move across AP?
Hi, We had a deployment of centralised WLC (earlier 3504) with flexconnect configured for remote sites (centralized auth, local switching, ISE CWA. ISE, WAPs and clients are on same LAN). These sites are connected to the controller using satellite li...
