Hi, we have a Cisco ACI in our LAB enviroment with an older version 2.2. We'd like reset/clean all the fabric (n.3 APIC,n.2 Leaf and n.2 Spine) and restart with a new version, the 5.2. Our hardware support it We don't need the backup of actual config...
when I'm at the cisco asr console, why can't I type anything after "Press RETURN to get started!" I use a Cisco USB to USB console with a putty baud rate of 9600, can anyone help solve this problem?
I have static default route configured in L3out-01 I have multiple OSPF L3outs with 0.0.0.0/0 and both “Export Route Control Subnet” and “Aggregate Export” are enabled I need to filter default route when exporting route from one of the OSPF L3out. ...
We have a UCS C240 M4SX that is out of coverage now (no contract) though the plan is to replace this with a new server, but for now we're stuck with it. The problem is, virtual disk 0 is down because we have 2 disks (1 and 2) that were in a predicted...
Here is the use case: I have two ACI sites (A and B) and running as multisite architecture. Each site has its own local only networks and there are also networks are L2 stretched between the sites. Each site has its own local L3Out (EIGRP based as an...
Hi,After removing from controller the last spine from Pod 1 in a multi-pod fabric (version 5.2(7g)), what I have is Pod 2 and 3 having leafs and spines, and Pod 1 without any switch. At that moment I have a lot of interface tunnels on spines and leaf...
Hello all,Maybe this question was published before but i was unable to find an answer that solvedy issue.I acquired an UCS C240 M4 recently with firmware version 2.0.I upgraded to version 4.2 without problem.Since I had no access to the CIMP web int...
Hi Guys, I am gathering some info from one ACI Fabric, my end goal is to get the moqueries with grep filters to list out all the ip's configure on the l3outs. Rather it the routed interface or svi. Need Help
Hello all,Long story but I had a lab upgrade from 5.2 to 6.0.5(M) fail on older APIC-M2's, and Cisco TAC suggested a fabric rebuild. Since I have newer APIC-M4's, I decided to install 5.3.2b on my APIC-M4's, and rebuild my lab fabric using those. All...
Does any has been able to install Windows server 2012 On a B200 M3 blade running 2204XP As fex with VIC 1240 card installed in blade. I am running 2.0(4b) On B 200 M 3 blades & while trying to install Windows 2012 . It installed succesfully since i a...
I bought a c220 off eBay and I’m trying to set it up but the admin password option is not able to be set, when accessing the CIMC it’s showing logged in as User every time. That password is set but it the CIMC won’t start under administrator, I’ve b...
Hello, I have a L3Out connected to a cluster of 2 physical Firewalls with 2 VPC links. the 2 VPC links uses vlan 200. I want to use that l3out in a service graph as PBR destination. the vlan 200 is a part of a L3 domain When creating L4-L7 device, I ...
Which VMWARE license is to be bought with cisco ucs220 to build a vmware vsan certied server solution Server is Cisco UCSC-C220-M6S UCS C220 M6 Rack w/o CPU, mem, drives, 1U wSFF HDD backplane Each Server has 2x UCS-CPU-I6326 Cisco Intel Xeon Gold...